Author Topic: EC18 pin 1  (Read 4769 times)

Offline Seight-v8

  • Sr. Member
  • ****
  • Posts: 339
  • BHP: 6
    • Members Page - Scott Richmond
EC18 pin 1
« on: January 02, 2014, 07:51:11 pm »
hello all,

Originally I had EC18 pin one wired to my first knock sensor, but when I installed dual lambda's I had to use pin 1 for this......

This leaves me with wiring in my knock sensors some other way...anyone help out here.....how or what do I have to do to get them working again, or will I now not be able to wire them back in?

Not sure which input I can use, as I have dual knock sensors, sensor two is wired to EC18 pin 3, and the grounds for both on EC18 pin 2, but I need an input for sensor 1, which is now a lambda input.

cheers for any help

scott
Engine:Rover V8 4600cc
Vems Firmware:V1.2.38, GPS, SDcard, LCD & Dual lambdas, Wasted spark, 36-1 trigger, Cam Sync & Bluetooth serial.

http://www.vems.hu/wiki/index.php?page=MembersPage%2FScottRichmond

Offline Seight-v8

  • Sr. Member
  • ****
  • Posts: 339
  • BHP: 6
    • Members Page - Scott Richmond
Re: EC18 pin 1
« Reply #1 on: January 03, 2014, 02:52:16 pm »
ok so I pulled the ecu out today to see how its wired.....

I've disconnect EC18 pin6, as I don't use it and re-wired it for my knock sensor....so this should do the trick....

Not that I am using any knock sensors at the moment, just want to be ready for when this does get implemented...

scott
Engine:Rover V8 4600cc
Vems Firmware:V1.2.38, GPS, SDcard, LCD & Dual lambdas, Wasted spark, 36-1 trigger, Cam Sync & Bluetooth serial.

http://www.vems.hu/wiki/index.php?page=MembersPage%2FScottRichmond