First Attemp:
36-1 vr trigger is usable. The tdc after trigger is 90 degree like Ford Edis.
(First we try with reverse polarity but after the right polarity we get rpm signal at cranking)
VEMS onboard map sensor against o.e. Hose from the plenum, from the original place.
Marelli IAT sensor against o.e. Put with m14x1.5 thread in the plenum.
No CLT sensor. 4.7k potentiometer used. Manually adjusted to 75-80 Celsius.
Injectors are usable. Approx. 160-200 ccm.
No IAC, idle adjust manually to 900 rpm.
Wide band EGO sensor in original place.
Coil and distributor drive by IGBT. Coil primary resistance approx 0.8 ohm.
Knock sensor on the side of the block with R-C signal conditioner into mic input.
Using spectrum analyser program to detect knocking.
Firmware 1.1.27 12x12
VE table from Megatune table generator
Spark from
www.powerpage.dk Ignition Timing Configurator xsl
Lamba 1.00 from 0 to 50 kPa, richer above.