Hi, please, I am a bit confused from anytrim settings;
1] boost:
I'd like to use anytrim for boost target change. Example: when I lower boost target from 250kPa to 180kPa (spring is 160kPa) via anytrim, boost refDC table remains unchanged (or vice versa; I lower refDC via anytrim but boost target remains unchanged). How about PID regulation then ? Will it work ?
2] launch:
The same for launch settings. Is it possible to change launch curve via anytrim or it will change only static launch RPM ?? (As input for anytrim wheelspeed1 or AD1-7 ?)
Thanks.