« previous next »
Pages: [1]

Author Topic: Missing tooth primary trigger on camshaft  (Read 5609 times)

Offline Cornelius

  • Jr. Member
  • **
  • Posts: 7
  • BHP: 0
Missing tooth primary trigger on camshaft
« on: November 28, 2012, 10:22:33 pm »
Need help to configure 48-2 prim.trigger on camshaft,Angular Width Of Tooth=15 crankdegrees.Engine is 1 cyl. 4-stroke , 1 event every 48 teeth.Can vems handle such trigger?
Logged

Offline GintsK

  • Hero Member
  • *****
  • Posts: 1257
  • BHP: 50
Re: Missing tooth primary trigger on camshaft
« Reply #1 on: November 29, 2012, 07:10:22 am »
I think it should. Your settings seems correct. Ref tooth table may consist from one 0.
Then you can capture trigger log where you'll see where the power stroke TDC is - slowest sector along one cycle.

Gints
Logged

Offline Cornelius

  • Jr. Member
  • **
  • Posts: 7
  • BHP: 0
Re: Missing tooth primary trigger on camshaft
« Reply #2 on: November 29, 2012, 08:45:24 am »
I've made some bench tests, everything seems to work fine , but I am worrying about the errors on the pri.trigger setting menu  ::). should I ignore them?
Logged

Offline GintsK

  • Hero Member
  • *****
  • Posts: 1257
  • BHP: 50
Re: Missing tooth primary trigger on camshaft
« Reply #3 on: November 29, 2012, 09:47:01 am »
I think you can ignore them. If your triggerlog seems correct.

1.2.x firmware gives also spark and triggering error events in triggerlog. Did you tried?
Logged
Pages: [1]
« previous next »