Missing tooth primary trigger on camshaft

[Cornelius]

Need help to configure 48-2 prim.trigger on camshaft,Angular Width Of Tooth=15 crankdegrees.Engine is 1 cyl. 4-stroke , 1 event every 48 teeth.Can vems handle such trigger?

[GintsK]

I think it should. Your settings seems correct. Ref tooth table may consist from one 0.
Then you can capture trigger log where you'll see where the power stroke TDC is - slowest sector along one cycle.

Gints

[Cornelius]

I've made some bench tests, everything seems to work fine , but I am worrying about the errors on the pri.trigger setting menu  ::). should I ignore them?

[GintsK]

I think you can ignore them. If your triggerlog seems correct.

1.2.x firmware gives also spark and triggering error events in triggerlog. Did you tried?