ok so i've been up and running with 1.1.27 for a little bit now.
i'd like to continue working on fine tuning my boost controller settings.
I'm using open loop control, and would like to add in the DC correction but i'm still unsure what type of signal its looking for??
My situation is that i have the 'actuator off below this kpa' to 170. this creates some real fast boost build up, but overshoots my target slightly and then drops and levels off.
If i set the kpa lower, i hit my target but its a much slower build (not as fun!)
will i be able to obtain my goal using open loop? should i try the closed loop? i'd rather not go back to PID tuning