Setup stepper

[306 2.0 16v]

Hello. I have put a vems on my peugeot 306 2.0 16v and keep many of the same settings that I had on my old peugeot 205 2.0 8v. but the new car running with a stepper instead of a acuacot. and I do not know how to get it to work. it is connected in the sense that the EC 18 is set to pin10 two A pin11 two B pin 5 to C pin 4 to D ..
but how should the control of mega tune I run with the old version 1.0.53
hope to have someone who can help me.

regards dennis

[Kamuto]

Hello. I have put a vems on my peugeot 306 2.0 16v and keep many of the same settings that I had on my old peugeot 205 2.0 8v. but the new car running with a stepper instead of a acuacot. and I do not know how to get it to work. it is connected in the sense that the EC 18 is set to pin10 two A pin11 two B pin 5 to C pin 4 to D ..
but how should the control of mega tune I run with the old version 1.0.53
hope to have someone who can help me.

regards dennis

download vemstune + use newer firmware. http://vems.hu/download/v3gui/NIGHTLY/

[306 2.0 16v]

Thanks for your reply. It seems to idle works now.

so now all I need to get the engine to take rpm. it will only go up in rpm when it reaches 50% throttle.

thanks dennis

[gunni]

It´s best to post a log and config.

you can even do that from within Vemstune, which you should be usinga and post the link to here.