Hi All
I'm at the point of having to turn the key for the first time - but I'm sure there are still somne things to do..... Here's a quick summary of my ststus:
Audi URS4 AAN engine with both supercharger and turbo.
5 cyl
COP
850cc injectors
Power target 700hp
2.2l
original wastegate, idle control etc
Progress to date:
New installation of VEMS 3.6 on 1.1.95 with separate 55pin to EC18/36 connector soldered a cording to an AAN_Build_Doc and pinout received with the unit. Still have to solder the PC interface connector - not sure about the pinout.
I'm also not clear as to how to load the config files / set them up for the injector size, nor any other small setup/configs to do. I have worked with 55pin VEMS before on this car (borrowed from a mate) and it ran well. So tuning etc relatively comfortable with - but the unit came setup already for AAN, this time I had to use GEN 3.6.
So what did I forget. I assume I have to check all the sensor calibrations - i.e enter the config values for the WBO2 etc I received with the unit, but what else is there, or do I turn the key..
Is version 1.1.95 ok for AAN, or should I be using something else?
thanx
Bambi