« previous next »
Pages: [1]

Author Topic: Warning channel  (Read 5944 times)

Offline B3mt1

  • Jr. Member
  • **
  • Posts: 13
  • BHP: 1
Warning channel
« on: June 26, 2012, 07:50:57 pm »
I have question about powering up LED when my oil pressure drops below some value. When engine is off (oil pressure=0bar adc raw value channel 5 is 0.5 volts). So when i have set values like in picture i should not have contact to ground, but i have. What am i doing wrong, please help.
Logged

Offline gunni

  • Hero Member
  • *****
  • Posts: 1492
  • BHP: 37
Re: Warning channel
« Reply #1 on: June 26, 2012, 10:36:24 pm »
What value do you want it to be?

try 6 inverted.

Logged

Offline GintsK

  • Hero Member
  • *****
  • Posts: 1257
  • BHP: 50
Re: Warning channel
« Reply #2 on: June 27, 2012, 10:51:38 am »
Minimum rpm/kpa window is off!
Logged

Offline B3mt1

  • Jr. Member
  • **
  • Posts: 13
  • BHP: 1
Re: Warning channel
« Reply #3 on: June 28, 2012, 11:27:10 am »
Ok, now i am completely confused. All i want to light up LED when adc raw value drops below some value, i don't care about coolant temp, CE light or anything else. How should my settings look like ?
Logged

Offline mattias

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1075
  • BHP: 41
    • Sävar Turbo Site
Re: Warning channel
« Reply #4 on: June 28, 2012, 11:35:23 am »
Start off by doing what Gints said, put 0 for both rpm and kPa.

Press F1 for help in the dialog, with any kind of reasoning ability you should be able to figure this out.
Logged
Pages: [1]
« previous next »