1.2.10 Issues

[billman]

I started a new thread here in order to see If other experience the same.

I updated to 1.2.10 and noticed the following:

When choosing the Divby9 settings from the dropdown menu on Primary Trigger settings something occurs I think and the config goes bad.

I did a manual Divby9 Setup and it works without issues.

But I noticed the following: With 1.1.96 TDC before trigger was 59 (Divby3). with 1.2.10 and Divby3 I had to set it at 56 and now with Divby9 I had to set it at 53! Why is that?

[GintsK]

Yesterday I tried div by 9 on fresh installation. And got even 51deg. But angle was stable, and everything else what I test worked OK.

[billman]

Did you choose the Divby9 settings from the drop-down menu or did you used another previous config that was on Divby9?

[GintsK]

From dropdown. But then adopted to my IGn table. And maybe "RPM filter, cam based trigger" was active.

[billman]

I tried twice from the dropdown menu to change from Divby3 to divby9 and both times I had issues.  I am curious to find out why that happened.

Did you noticed less trigger errors with the 1.2.x versions?

I noticed the car starts up much quicker. Less cranking time.