« previous next »
Pages: [1]

Author Topic: ignition drivers  (Read 4922 times)

Offline reevio

  • Jr. Member
  • **
  • Posts: 72
  • BHP: 1
ignition drivers
« on: September 25, 2011, 05:29:09 pm »
why would they keep blowing on my coil cheers
Logged

Offline GintsK

  • Hero Member
  • *****
  • Posts: 1257
  • BHP: 50
Re: ignition drivers
« Reply #1 on: September 25, 2011, 07:49:26 pm »
if you blow your coil current is too high.
It can be too high because of:
-dwell time configured too high
-wrong polarity of signal to IGBT
-IGBTs already fried and keep coils energized all the time
-shortcut to ground between IGBT and coil
-...

Could you be more detailed about your setup?
Have you a fuse installed?

Gints
Logged

Offline reevio

  • Jr. Member
  • **
  • Posts: 72
  • BHP: 1
Re: ignition drivers
« Reply #2 on: September 25, 2011, 08:27:54 pm »
right i run a single coil pack its currently running on 2 cyclinders due to one ignition driver blowing and only leaving half the coil working
it did this exact same thing on another coil pack and got fix by gunni im not sure if there are any fuses fitted . will they be inside the vems unit ? also what is igbt?
Logged
Pages: [1]
« previous next »