Knock sensor SD-logger problem

[andreNL]

Hello
I'm not using the SD-Logger function so its setting is disabled.
When i set knock channel to zero i get a error, SD-LOGGER says invalid (unknown setting).
Changing it back to disabled also Changing the knock channel to 240.  ???
Checked the configuration file but cant find the SD log settings.

[mattias]

Stay away from testing the knock code until a firmware has been officially released that has Andreys new "alternative" knock code. 

These are the dialogs that affect what you're speaking of.

[andreNL]

Yes those are the screens,
I Tried to get the knock sensor working to tune the ignition table i have.
it works well but i dont know if its perfect for my engine under boost.
is there an other way to check ignition advance?
Cheers andré

[mattias]

Get some det cans and/or go to a dyno facility.
Like I said, if you try to use the knock code, you're on your own.

[gunni]

Yes those are the screens,
I Tried to get the knock sensor working to tune the ignition table i have.
it works well but i dont know if its perfect for my engine under boost.
is there an other way to check ignition advance?
Cheers andré

That is a terrible idea to rely entirely on a knock detection code that almost nobody uses to adjust your ignition advance.

Do what Mattias suggests.

[andreNL]

Ok thx for the advise i make a apointment at a facility,
BTW i checked my log files and its registrating knock signal so its working :)
For setting factory ignition advance i had to lean out almost till stalling at 950rpm
It idles smooth around 1250 think the performance cams and bigger throttlebody is the cause hahahaha

[billman]

what settings did you use for it? I would like to test them.