high idle

[reevio]

my idle wont drop below 1600 rpm anything i can do ?

[mattias]

Adjust the throttle stop? If it's bottomed out, you have an air leak somewhere after the throttles.
I'm assuming here you don't have a runaway IAC valve.

Also try a pressure test, pressurize the whole intake system (with WOT).

[reevio]

whats the best way to test the iac valve as i tried adjuting it in vemstune and nothinng happened iac lock?

[[email protected]]

Establish its type, disconnect the power to it and force the thing closed (depending on it's type).

[reevio]

its a bosch 3 pin type perminant 12v and switches either side

[mattias]

Make sure you're using a suitable control frequency for this valve, too high and the valve may "freeze". I recommend 50-75 Hz, that sort of rocks it loose to move freely. You should be able to hear the control frequency and test it successfully with the"IAC lock" function.

[reevio]

ive removed the idle air valve all together and it makes no change to the idle at all sitting around 1600-1700rpm with it blocked up completely and ive sprayed cold idle around the inlet while on idle and no change to the idle at all ?

[reevio]

doh idle screw had worked its way loose from the vibrations most simple thing i didnt check cheers quys

[boostd audi]

its nice when its something simple..

[reevio]

yeah just got to get the wideband working now

[boostd audi]

whats going on with it.. did you configure it with VT. 
did you enter your info provided with your ecu? 

i find effective planning really saves time and energy spent on your ecu.. i make a couple documents before i even make a harness.  To make sure i have all output/input assigned etc  and it does help save time later..

[reevio]

tried getting it to configuire with vt and cant get it to heat ive connected onto the 5 wires which i think are correct leaving one which is the rcal connection not sure if this needs anything?

[boostd audi]

pin 2 is not used for wbo2

see here