« previous next »
Pages: [1]

Author Topic: Idle Timing correction disabled in 1.1.81-1.1.84?  (Read 7481 times)

Offline lugnuts

  • Full Member
  • ***
  • Posts: 249
  • BHP: 2
Idle Timing correction disabled in 1.1.81-1.1.84?
« on: February 06, 2011, 11:48:45 pm »
Has something been changed in the Idle Timing Correction in FW 1.1.81-1.1.84?

I could not get it to enable yesterday during testing.
Logged

Offline mattias

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1075
  • BHP: 41
    • Sävar Turbo Site
Re: Idle Timing correction disabled in 1.1.81-1.1.84?
« Reply #1 on: February 07, 2011, 12:11:38 am »
Never had any issues with idle timing on those firmwares. Datalog or it didn't happen.
Logged

Offline lugnuts

  • Full Member
  • ***
  • Posts: 249
  • BHP: 2
Re: Idle Timing correction disabled in 1.1.81-1.1.84?
« Reply #2 on: February 07, 2011, 04:49:29 am »
lol I knew that was coming.    Tomorrow.     TPS was 0% (threshold was 1%)   Changed idle speed from 950 to 300 and the timing just sat there and looked at me.   
Logged

Offline Denmark

  • Hero Member
  • *****
  • Posts: 542
  • BHP: 7
Re: Idle Timing correction disabled in 1.1.81-1.1.84?
« Reply #3 on: February 08, 2011, 05:20:22 pm »
i have had the same problem on some cars!


/Skassa
Logged
working on the boxer

Offline Kenny Watson

  • Jr. Member
  • **
  • Posts: 44
  • BHP: 3
Re: Idle Timing correction disabled in 1.1.81-1.1.84?
« Reply #4 on: February 11, 2011, 12:47:24 am »
Mine works perfectly. 1.1.81 here.
Logged

Offline Ignitec

  • Jr. Member
  • **
  • Posts: 90
  • BHP: 7
Re: Idle Timing correction disabled in 1.1.81-1.1.84?
« Reply #5 on: February 21, 2011, 09:40:37 pm »
Three cars last days, 1.1.84, works just fine.
Logged
If you have everything under control, you\\\'re not fast enough!

Offline lugnuts

  • Full Member
  • ***
  • Posts: 249
  • BHP: 2
Re: Idle Timing correction disabled in 1.1.81-1.1.84?
« Reply #6 on: March 12, 2011, 06:24:18 pm »
I found an issue that is causing strange ignition values, that complicated this situation.

If the idle speed is lower than the lowest ignition table rpm setpoint, the actual ignition advance is reduced, I assume because it is reverting to the Cranking Advance setting (In my case, 6 degrees)

I assumed that the Cranking Advance was ignored after the Cranking threshold RPM (299 in my case)

Logged
Pages: [1]
« previous next »