« previous next »
Pages: [1]

Author Topic: 12v Hall  (Read 6566 times)

Offline z0tya

  • Sr. Member
  • ****
  • Posts: 252
  • BHP: 11
12v Hall
« on: February 14, 2011, 07:54:47 am »
How can I use the oe hall sensor if it was with 12v by the original ecu?
Does it work with 5V? Can I supply with VEMS 5V pin?
Does any difference between 5V supply (pin 28) and TPS supply (pin 29)?

Thy
Logged

Offline GintsK

  • Hero Member
  • *****
  • Posts: 1257
  • BHP: 50
Re: 12v Hall
« Reply #1 on: February 14, 2011, 11:45:03 am »
What particular sensor? For old bosch ones I always use 5V with success.

And yes - there is difference. TPS supply is just for TPS: inside ecu is IIRC 270Ohm resistor in series. Any additional current in this supply wire will change TPS signal.
So use another 5V.
Logged

Offline z0tya

  • Sr. Member
  • ****
  • Posts: 252
  • BHP: 11
Re: 12v Hall
« Reply #2 on: February 14, 2011, 01:05:25 pm »
Bosch 0 273 008 002 , I have not found datasheet for it.
It is in a small turbo Escort Cosworth (EECIV)

Thx the info about 5V
Logged
Pages: [1]
« previous next »