Safe Mode

[andreNL]

After filling the tables and setting all items
i uploaded the firmware again (1.1.84) and hit 'OK' when asked for uplading configuration
like written in the wiki but the safe mode stays in safe mode 
any sugestions? can i set something in the configuration file to disable safe mode?
cheers andre

[GintsK]

What you mean under safe mode? Boot mode?

[andreNL]

Not boot mode, the new safe mode feature in Firmware 1.1.84
To disable ignition and injectors while updating firmware

[GintsK]

In wiki you wrote about communication problems. You can try one of VT versions from nightly builds with commModelTesting. It seems the most stable ever regarding communications.
Safe mode works so - during fw upgrade outputs is automaticaly configured in off position. When you load normal configuration, there is description of every output - everything after config upload should be operational.
Heve you a working config for previous fw? If no - start with default config. But always take care about ign outputs.

[andreNL]

I Tried the comm model 2010-11-26 and 2010-12-3 but These are even worse
Most stable for me is 2010-11-15 official release and this one hangs up to.
My Vems unit works fine all input is ok output to fuelpump ect starts and stops ok
Triggers working just need to unlock the safe mode to try and start my engine.
Uploaded fw 4, 5 times but still locked. I make a new cable to rule out bad cable connection.
See if it helps

[andreNL]

I changed the cable, no differance
If i Upload config the cpu goes to 100% and the upload dialog shows a red turning bar
For more then 15 minutes and counting.
Has it something to do with table sizes?
Batterij voltage 12.6v
config table size 12x12
Ecu table size 16x14
laptop hangs after this message going to 100%