New software with fully configurable lambda output -Problem-

[mantamadsen]

Hello

I come from denmark, so my english is not so good :)

After many hours i finally think that i have figuret out the problem in the software.
I figuret out that the numbers in the fully configurable lambda output is -0.2, that
say that the numbers 0.7, 0.9, 0.95, 0.98, 0.99, 1.0, 1.01, 1.02, 1.05, 1.1, 1.2, 1.4, 1.7
is instead 0.5, 0.7, 0.75, 0.78, 0.79, 0.8, 0.81, 0.82, 0.85, 0.9, 1.0, 1.1, 1.5. I dont now
how too fix it in the software, but i hope somewon now how too do it

Martin Madsen
Denmark

[[email protected]]

Hi,

What is pin 9 (Lambda signal ground) connected to?

[mantamadsen]

Hello Rob

It goes too the same ground as the Engine computer.
But also if you look at the calculated Vout in megatune, it
is something wrong.

Martin Madsen

[[email protected]]

Can you do a snap-shot of your MegaTune screen so we can see all the settings?