« previous next »
Pages: [1]

Author Topic: VEMS support LSU 4.9 (4-93)?  (Read 9378 times)

Offline krzycho-g

  • Jr. Member
  • **
  • Posts: 26
  • BHP: 0
VEMS support LSU 4.9 (4-93)?
« on: August 27, 2010, 06:37:11 pm »
Hello

I'm ask, because i had LSU 4.2 in my car and all its ok. Now installed LSU 4.9 , calibrated, run engine , after 10 second i have not read and can no longer calibrating this sensor
I've just damaged the second  :'(

Kris
« Last Edit: August 27, 2010, 06:48:20 pm by krzycho-g »
Logged

Offline gunni

  • Hero Member
  • *****
  • Posts: 1492
  • BHP: 37
Re: VEMS support LSU 4.9 (4-93)?
« Reply #1 on: August 27, 2010, 09:32:20 pm »
Why did you install a 4.9 sensor without checking first?
Logged

Offline lugnuts

  • Full Member
  • ***
  • Posts: 249
  • BHP: 2
Re: VEMS support LSU 4.9 (4-93)?
« Reply #2 on: August 27, 2010, 10:49:36 pm »
Speaking of....  would it be possible to use an NTK sensor with the VEMS hardware as-is?
Logged

Offline krzycho-g

  • Jr. Member
  • **
  • Posts: 26
  • BHP: 0
Re: VEMS support LSU 4.9 (4-93)?
« Reply #3 on: August 28, 2010, 05:48:06 am »
just i dont know.. ;D
and my 200 $ bye bye  :'(

that is not possible, right ?
Logged

Offline paul_f

  • Full Member
  • ***
  • Posts: 120
  • BHP: 8
Re: VEMS support LSU 4.9 (4-93)?
« Reply #4 on: August 29, 2010, 02:02:26 pm »
Quote from: lugnuts on August 27, 2010, 10:49:36 pm
Speaking of....  would it be possible to use an NTK sensor with the VEMS hardware as-is?

I was told you could

http://www.vems.hu/wiki/index.php?page=MembersPage%2FPaulF%2FEFIComponents

I haven't tried it yet though, the sensor is still sitting in the box!  I couldn't find the pinout of the sensor I had and so took the easy option of getting the Bosch sensor
Logged
Pages: [1]
« previous next »