Shift cut, fixed ignition Fw 1.2.38

[Morty]

I’m trying to setup my shift cut and when setting the fixed ignition to 20˚ ATDC, the ignition goes to 0,5˚ ATDC when shift cut is active, same if I set it to a higher degree ATDC. If I set it to 0˚, it goes to 0˚.

Is there a setting elsewhere affecting this or there is a bug in the software? Anyone who knows?

[Morty]

Found the setting in the menu for Ignition setup. There was a setting not allowing the ignition to go lower/later then 0. I adjusted it to -20 and now it works.