Author Topic: Shift cut, fixed ignition Fw 1.2.38  (Read 6021 times)

Offline Morty

  • Jr. Member
  • **
  • Posts: 32
  • BHP: 4
Shift cut, fixed ignition Fw 1.2.38
« on: August 15, 2022, 10:26:57 am »
I’m trying to setup my shift cut and when setting the fixed ignition to 20˚ ATDC, the ignition goes to 0,5˚ ATDC when shift cut is active, same if I set it to a higher degree ATDC. If I set it to 0˚, it goes to 0˚.

Is there a setting elsewhere affecting this or there is a bug in the software? Anyone who knows?

Offline Morty

  • Jr. Member
  • **
  • Posts: 32
  • BHP: 4
Re: Shift cut, fixed ignition Fw 1.2.38
« Reply #1 on: August 15, 2022, 02:12:49 pm »
Found the setting in the menu for Ignition setup. There was a setting not allowing the ignition to go lower/later then 0. I adjusted it to -20 and now it works.