« previous next »
Pages: [1]

Author Topic: WOT - shift cut time set to 1020 issues  (Read 9174 times)

Offline RazOn

  • Jr. Member
  • **
  • Posts: 53
  • BHP: 0
WOT - shift cut time set to 1020 issues
« on: February 05, 2017, 09:00:09 am »
I have a sequential gearbox that has output signal to reduce torque for gear change. It removes the signal one the shift is complete.
I set the shift cut time to 1020 so that power will be cut for as long as the transmission needs to change the gear.
However, I noticed that after transmission removes the signal, VEMS still cuts spark in my case for another ~100ms. This makes for very slow shifting (relatively speaking).

Anybody know how to make it better?
Logged

Offline RazOn

  • Jr. Member
  • **
  • Posts: 53
  • BHP: 0
Re: WOT - shift cut time set to 1020 issues
« Reply #1 on: February 07, 2017, 05:29:32 am »
New firmware fixed it!
Logged

Offline Kamuto

  • Hero Member
  • *****
  • Posts: 814
  • BHP: 19
Re: WOT - shift cut time set to 1020 issues
« Reply #2 on: February 07, 2017, 11:41:17 am »
Quote from: RazOn on February 07, 2017, 05:29:32 am
New firmware fixed it!
good to hear :)
Logged
Vems installer in Lithuania
valdas.sunokas@gmail.com

Offline Morty

  • Jr. Member
  • **
  • Posts: 32
  • BHP: 4
Re: WOT - shift cut time set to 1020 issues
« Reply #3 on: October 03, 2022, 05:41:20 pm »
I have the same issue on firmware 1.2.38. Which firmware version should I go for. A local VEMS dealer updated to this and said it was the one he recommended.
Logged
Pages: [1]
« previous next »