Technical > Wiring & Sensors
Install wiring Help needed
volvotech:
Hi Rob
Stuck again,how do i configure ign outputs,read install page & i didn't seem to learn much,do i config like inj outs in reverse order.
Thanks Adrian
rob@vems.co.uk:
Trigger setups are confusing, but you only have to do this once, I've spent an hour or so this morning doing this:
http://www.vems.hu/wiki/index.php?page=VehicleFitment%2FTwentyFourPlusOneTrigger
The 8-cylinder one has the settings that you're wanting to use, what I'd suggest is that you use the config and tables files from the running Supra:
http://www.vems.hu/files/Fero/Supra/config.txt
http://www.vems.hu/files/Fero/Supra/tables.txt
And the 1.1.18 firmware:
http://www.vems.co.uk/VEMSTech/VemsMT1.1.18.zip
You'll not need to modify your trigger hardware.
rob@vems.co.uk:
--- Quote from: volvotech on May 19, 2007, 08:52:17 pm ---Stuck again,how do i configure ign outputs,read install page & i didn't seem to learn much,do i config like inj outs in reverse order.
--- End quote ---
Yep, in reverse order...
I tend to wire coils in the order: Coil 00 cylinder 1, Coil 10 cylinder 2 ... Coil 70 cylinder 8.
Others claim that the best idea is wire them in the firing order (assuming 1, 3, 4, 2)
With firmware from 1.073 and up the coil numbering in h2[] is number first:
10 30 20 00
volvotech:
Hi Rob
Thanks for your quick reply,that all makes things clearer & easier for me ,just got one last query today(this means there will be more later.
In Twenty Four Plus One Trigger * cylinder config page
Line as follows is this correct??
rpmk[1]=e8 #RPM constantfor 4 cyl = 3000 (=0x03E8)
thanks Adrian
ps If you dont mind when i have finished with wiring & settings will post my data for you to look at before i attempt engine start
rob@vems.co.uk:
Well spotted! It should be:
rpmk[0]=05
rpmk[1]=DC #RPM constant for 8 cyl (12000/8) = 1500 (=0x05DC)
Before you try to start you should spin the engine over without any ignition or injection compoents in place, plugs out too!
Take a butchers at:
http://www.vems.co.uk/VEMSLoom/LoomGuideUnitXXX.doc
It gives you a step-by-step approach to configuring the specifics of your install, battery constants etc.
I'll happily look over your config and tables files, and will test them on the bench. I've got some test patterns that you can play through your sound card to test against.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version