Technical > Wiring & Sensors

Install wiring Help needed

<< < (3/3)

volvotech:
Hi Rob
thanks again,looks like im not quite as daft as i think.
all your help much appreciated.Got a heavy week at work so i probably wont bother you till early next week now,by which time i will hopefully ready for a test start,been a bit sharp with wiring & built spare dash/bulkhead loom for VEMS to plug to my existing bay loom,so can test on car before pulling dash to change loom.
many thanks & regards Adrian

ps,i have just finished my 1st 1uz-fe t0 tremec t5 bellhousing (Hydralic Clutch slave)today,going to drop in at a alu foundry ive used before for price for casting a few,will keep posed when have more info.(Hydralic Clutch slave).

volvotech:
Hi Rob
im stuck again.
re:coil output h[2] config,
in twenty four one file coil syntax 00 10....70
in forum help 00 01...07
looks like should be 10 20....70 to me but im usually wrong with these things
thanks Adrian

rob@vems.co.uk:
No, you're right, I'm wrong, in the newer releases you need to use:
 10 30 20 00

I will edit the other post accordingly.

Sprocket:

--- Quote from: rob@vems.co.uk on May 16, 2007, 09:10:47 pm ---A 5 wire IACV!  Got any info on that?
Theres a number of possible IACV options if you're moving from stock.

--- End quote ---

Rob I have done the research on the five wire unipolar steppers, have a look through my 1400 thread.

when I get a little more time I'll get it in black and white and more concise :-\

Navigation

[0] Message Index

[*] Previous page