Author Topic: Question about pinout 3.6  (Read 6220 times)

Offline Ignitec

  • Jr. Member
  • **
  • Posts: 90
  • BHP: 7
Question about pinout 3.6
« on: June 17, 2010, 12:27:22 pm »
I'm looking at this pinout http://195.159.109.134/vemsuk/forum/index.php/topic,1266.0.html for 3.6 board and would like someone to confirm ground at pin 17 of ec18 connector. At bottom side of the board there's clearly visible connection between pin17 and fet next to wbo2 heater fet.
If you have everything under control, you\\\'re not fast enough!

Offline jrussell

  • VEMS USA
  • Administrator
  • Full Member
  • *****
  • Posts: 224
  • BHP: 15
    • VEMS USA
Re: Question about pinout 3.6
« Reply #1 on: June 17, 2010, 09:36:51 pm »
Depending on when your board was built, it may not be ground. That is a recent decision as far as I know (to make it easier to wire up rs232 on the EC18). Surely go with what is actually wired on your board versus documentation though.
VEMS USA - Located in beautiful Burlington, Vermont
1988 RX7 Turbo

Offline Ignitec

  • Jr. Member
  • **
  • Posts: 90
  • BHP: 7
Re: Question about pinout 3.6
« Reply #2 on: June 18, 2010, 08:09:53 am »
Thank you very much!
If you have everything under control, you\\\'re not fast enough!

Offline lugnuts

  • Full Member
  • ***
  • Posts: 249
  • BHP: 2
Re: Question about pinout 3.6
« Reply #3 on: June 19, 2010, 02:54:02 am »
If you have an assembled ecu - use an ohm meter to check for connection between EC18-17 and EC36-26.