Connecting fuel level sensor to VEMS Round

[Grimmie]

Hi all,

I'm new here but using a VEMS Round for years now. It is my main AFR gauge and also connects to the MS DIY PNP.

I have recently changed my dashboard and removed the stock fuel gauge.

I have noticed the VEMS Round has a second line of digits which is now unused.
If possible I would like it to display the fuel level in my tank (so I don't run out ).

However I don't know where to start, anybody here how as som experience doing this and could help?

What I know:
Miata fuel sensor reads 5 Ohms full and 114 Ohms empty.

To which cable do I connect the sensor lead?
What settings do I use in the VEMS tune software?
And finally, is simply wiring it in enough, or will I need a signal conversion before wiring it in?

Hope someone can help, thanks!

[Kamuto]

Hi all,

I'm new here but using a VEMS Round for years now. It is my main AFR gauge and also connects to the MS DIY PNP.

I have recently changed my dashboard and removed the stock fuel gauge.

I have noticed the VEMS Round has a second line of digits which is now unused.
If possible I would like it to display the fuel level in my tank (so I don't run out ).

However I don't know where to start, anybody here how as som experience doing this and could help?

What I know:
Miata fuel sensor reads 5 Ohms full and 114 Ohms empty.

To which cable do I connect the sensor lead?
What settings do I use in the VEMS tune software?
And finally, is simply wiring it in enough, or will I need a signal conversion before wiring it in?

Hope someone can help, thanks!

you will need strong pullup to signal something like 500 ohm would work , pullup means resistor between 5v and signal wire, and then you need to calibrate some sensor