Author Topic: Table Switching not responding to selected switch  (Read 4842 times)

Offline RogueEngineer

  • Jr. Member
  • **
  • Posts: 3
  • BHP: 0
Table Switching not responding to selected switch
« on: May 24, 2021, 09:29:57 pm »
I've wired up a grounding switch that takes the Analog 6 (EC18) input from 5V to 0V.  I can watch the value go from 5V to 0V in the analog voltage display.

The goal here was to have a switch to idle-up with the AC on, but despite selecting this analog signal - there isn't any change in the idle IAC values when switched on.

As an alternative, I decided to try table switching using the analog 6 as the trigger.  Even though the signal goes low, the table doesn't switch. It stays with Config A. I've tried both normal and inverted Analog 6 selections.

I created a new "flag" beside the "Config A" flag that tracks the analog 6 voltage value (displays green or black if high/low). This triggers fine when hitting my switch.

It is unclear what the issue is at this point.

Any suggestions?

-Ian