[1.1.74] - release candidate, but not yet released
* more precise tach output frequency even at very high RPM
* up to 36000 output pulses per minute, that is 18000 RPM for "4 cyl" tachometer (which can be used even for 5-6-8-12 or other cyl count, just adjust the tach divider)
* LCD updates are synchronized to LCD refresh (when lambda changes from 1.00 to 0.99, 1.99 should not be intermittently displayed)
* cranking pulsewidth shown after powerup (even before trigger)
* improved ignition when trigger signal is extremely noisy during cranking at least for missing tooth trigger - not much can be done for "coiltype" trigger of course.
* InputTrigger/SubaruTrigger implemented. Unlike with 1.0.x, configured as coiltype (not missing tooth type).
Primary_trigger=A3 (or AB, as the missing tooth advanced filter can be enabled and configured for this, even though derived from the coiltype family.
Then we trig from the short "normal tooth", max 100% and neglect the long "missing tooth" eg. min 125% )
The weird subaru multipulse camsync requires another_trigger_tooth=03 and secondary_trigger=59 (bit6=1)
For the simpler fiatstilo campulse, another_trigger_tooth=01 applies and either secondary_trigger=59 or 19 should work.
* InputTrigger/LanciaCosworth (which was "coiltype" before, theoretically not changed, must also be retested.)
* Some small other changes, eg. warninglight sent instead of warmup (warmup light on when warmup_enrichment > 100% is calculated in vemstune)
* for launch, flamebit (a config bit) enables launch_enrich fadeout (partial sparkcut is good, but partial launch_enrichment will be normally disabled by most tuners to avoid exhaust bang and flame effects)
*als_iacpos;// iac position when ALS active (0 disables)
* communication protection against unauthorized (write / read) access (perhaps only in 1.1.71 : not certain if this will be available in the default compile after 1.1.71 ) only applied if config_ext.pwcommlock0 == DE ( decimal 222 )
than serialnum dependent password is needed for communication. Request password for the given serialnr when ordering.
Use GenBoard/Firmware/BootLoaderLoopback to upload an old firmware if you accidentally locked yourself out (that's why this is for experts only). No need to reenter password if reconnecting; Only needed after reboot (might be asked for only once on a certain notebook: if VemsTune saves it on the notebook harddrive and sends it automatically after that)
* important scheduler priority changes (effecting ign and lambda_target lookup)
