News:

When asking for technical help at the very least let us know the version of firmware you are running.
Cliff's Calibration (Mapping) Guide is a MUST READ: http://www.vemssupport.com/forum/index.php/topic,97.0.html

Main Menu

Temperature Sensor Configuration

Started by [email protected], May 01, 2007, 10:25:09 PM

Previous topic - Next topic
Print
Go Down Pages 1 2
User actions

MWfire

#15
February 23, 2009, 06:49:37 PM
I can make calibration file for your sensor. But you will need to change one resistor(pull up).

z0tya

#16
February 23, 2009, 07:09:23 PM
Can i do the pullup outside the vems box? Or just internal.
I don't want to dissasemble the box.

MWfire

#17
February 23, 2009, 09:04:12 PM
Quote from: z0tya on February 23, 2009, 07:09:23 PM
Can i do the pullup outside the vems box? Or just internal.
I don't want to dissasemble the box.

internal. I can make calibration file for serial vems resistor, but accuracy would be bad.
Or you can buy this sensor (1E)
http://shop.vems.hu/catalog/product_info.php?cPath=1_12&products_id=54&osCsid=a7e20411f9aff684f671964c4a438cfd

z0tya

#18
February 23, 2009, 09:22:13 PM
okay, thanks

i will use some better sensor than the o.e.

[email protected]

#19
February 23, 2009, 09:44:51 PM
Those early Ford ones seemed to be similar to the sensors that are used for the dashboard temp gauge.
The later Fords seemed to use thermocouples!

Get a nice Bosch style one.
Print
Go Up Pages 1 2
User actions