Hi guys!
My name is Chris and I am helping a friend to build a Peugeot 106 Turbo!
We bought a Vems v3.3 PnP 3plug from DP(along with some other stuff like manifold and wideband Lamda) with firmware 1.0.53.
We were using Megatune but I tried Vemstune and it needed at least 1.0.73 firmware, so I updated the vems firmware!
Here is our problem! We started building the maps but when then car reaches 4000Rpm(+- 5%) it starts backfiring and stalls!
Through this forum I started reading nearly every post regarding triggerring BUT I can't find the correct numbers...
We are using the standar 60-2 wheel...
The car was ok before the update(don't ask why I did the update...I liked Vemstune a lot!)!
My friend has another peugeot 106 with 1plug vems v3.3 PnP from DP too(which will be NA tuned with Jenveys throttle bodies)!
I checked the settings on the 1plug ecu and I have the same on the 3plug but it won't run...
After some emails with DP I disabled Launch control and ALS but the car does the same thing...
Any help much appreciated!
P.S.:DP told me that the firmware update voids my warranty! But I didn't read anything like this before I bought the ECU!!!