VemsTune and 1.1.6x release

[Tony C]

in firmware upload

device: v3
version: 1.1.64
type:?  ps2 or nonps2?

[dnb]

The lambda and ignition tables should already be the right size since the 1.1.5x firmware I put on with you.

Why's the engine out again??

[Sprocket]

The lambda and ignition tables should already be the right size since the 1.1.5x firmware I put on with you.

Why's the engine out again??

?? Im running 1.1.47 and I did it myself

And the engine is out because of this

[dnb]

Sorry - thought it was Tony taking the engine out again.    I can't read, you know

[Sprocket]

Ha ha no worries But from a recent previous post Tony said he is running 1.1.44

[Tony C]

i am running 1.1.44 

and yup engine maybe coming out to sort this over run oil burning fault.

as im snowed in today i may have a go at converting over to 1.1.64 and VT
 

[Tony C]

what is the ps or non ps bit about?
what do i need to set to?
when i save the current msq VT and load new firmware then upload the dloaded msq or vemscfg what ever its called will it set to 12x12?
and i gather i also need to do firmware validate etc after upload?

[MWfire]

non ps version has speed senzor.

[rob@vems.co.uk]

Does 1.1.6x still have switchable maps?

[Tony C]

i'll go with ps version then as have no speed sensor.
hoping to dig the garage out of the snow today can then have a go at mucking the ecu up 

[dnb]

I think the map switch is still there Rob. 

Tony - it doesn't matter whether you go for PS2 or non-PS2.  (I prefer non-PS2 because I was never really happy with the reliability of the PS2 keybord code)

The oil use issue is probably the cheap and nasty way Rover chose to implement the PCV system...  Easy to fix with a catch can.

[MWfire]

Does 1.1.6x still have switchable maps?

yes.

[Tony C]

it only burning oil on 2 cylinders mate, (plugs black)
gona change the two inlet seals on them two before we go any further

[dnb]

I see your point...  There's always the indian rope trick for getting the collets out of the valves.


Does anyone know an easy way to add new clt and mat definitions so that Vemstune picks them up nicely (ie without me messing about too much)?  I have a few to add, so would prefer not to use the trick of renaming and replacing existing definitions.  Thanks.

[Tony C]

HELP!!!!!
warmed the car up to make starting easier with new firmware, plus wanted to make sure car had a good battery after sitting in garage in freezing temps,

down loaded the config as per VT,
uploaded new firmware and config and validated, came up with a list of errors,
took ages for car to start and when it did it ran as if on half cylinders wont rev just pops and bangs and stinks of rich fuel,
its idling lower than it should and also the its higher up the kpa scale now too.
any ideas, any one need to look at any files to see what i have got wrong?