Author Topic: Genboard v3.6 vs v3.3 differences  (Read 8236 times)

Offline Pet

  • Full Member
  • ***
  • Posts: 121
  • BHP: 7
Genboard v3.6 vs v3.3 differences
« on: October 03, 2010, 11:09:30 am »
I've recieved my new Genboard v3.6, but I have only v3.3 schematic + v3.6 pinout. Does anybody know differences between these versions ?? For ex. wheel speed input configuration etc.

Offline mattias

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1075
  • BHP: 41
    • Sävar Turbo Site

Offline Pet

  • Full Member
  • ***
  • Posts: 121
  • BHP: 7
Re: Genboard v3.6 vs v3.3 differences
« Reply #2 on: October 04, 2010, 10:04:37 am »
Thanks, I have 3.6 pinout, but for ex. I know I have to solder some solder-blobs to enable primary VR circuit as well as 2nd trigger input (i want to use hall HALL). Another thing, there aren't marks on PCB with IC's orientation...,uff I'm sorry but I'm quite dissapointed about VEMS documentation, it's terrible :(

Note: pls, where to solder to enable 1st VR1 and 2nd trigger hall input ??
top:

bottom:


Offline mattias

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1075
  • BHP: 41
    • Sävar Turbo Site
Re: Genboard v3.6 vs v3.3 differences
« Reply #3 on: October 04, 2010, 10:35:44 am »
This is why you buy the ECU pre-assembled.
Documentation on this level is getting more and more hard to come by due to people copying the design.

Begin with these two links to get more informed :
http://www.vems.hu/wiki/index.php?page=GenBoard%2FManual%2FInputTriggerHardWare
http://www.vems.hu/wiki/index.php?page=GenBoard%2FVerThree%2FSchematic

Offline Pet

  • Full Member
  • ***
  • Posts: 121
  • BHP: 7
Re: Genboard v3.6 vs v3.3 differences
« Reply #4 on: October 04, 2010, 11:51:03 am »
Big thanks !!