Technical > Wiring & Sensors

what cable to use

<< < (2/3) > >>

ex-ctr:
http://cgi.ebay.co.uk/BLACK-Automotive-Thinwall-Cable-1sq-mm-32-0-20-16-5a_W0QQitemZ280074775520QQihZ018QQcategoryZ100921QQrdZ1QQcmdZViewItem

link to an ebay suplier in 10 mtr lenghts, i was thinking of ordering 10 colours

rob@vems.co.uk:
That looks like it might be a damn good find!

I usually use:
black for earth.
red for+12V feed.
brown for sensor ground.
blue for sensor signals.
yellow for +5V sensor feed.
Wire for odd injectors and coils.
Grey for even injectors and coils.

To indicate the coil and injector numbers I use a thin bits of heat shrink.

BenR:
Its Frustrating that all the different colour combinations required for a job end up costing a fortune.

Not cheap stuff wire......

damo_S13:

--- Quote from: rob@vems.co.uk on January 26, 2007, 05:57:56 pm ---For your CAS sensor you are going to want a 4 core sheilded wire, something like this:
http://www.maplin.co.uk/Module.aspx?ModuleNo=137&doy=26m1&C=SEO&U=strat15

Rob

--- End quote ---

for this i have just taken out the stock cable from the nissan loom will it be ok?

thanks
damo

rob@vems.co.uk:
I could think of nothing better to use TBH. Well apart from bling oxygen free super sheilded stuff.

Navigation

[0] Message Index

[#] Next page

[*] Previous page