When asking for technical help at the very least let us know the version of firmware you are running.
Cliff's Calibration (Mapping) Guide is a MUST READ: http://www.vemssupport.com/forum/index.php/topic,97.0.html
Subject / Started by | Replies / Views | Last post | ||
---|---|---|---|---|
49 Replies
32070 Views |
December 03, 2009, 01:20:29 am by Tony C |
|||
rev counter wiring
Started by karan |
5 Replies
6649 Views |
January 18, 2010, 07:13:48 pm by rob@vems.co.uk |
||
rev counter? Idle Air Controller (IAC)?
Started by damo_S13 |
5 Replies
8201 Views |
February 23, 2007, 11:49:59 pm by damo_S13 |
||
Road speed doesn't show anything.
Started by LuddeNo1 |
1 Replies
4318 Views |
June 30, 2015, 08:14:12 pm by gunni |
||
16 Replies
15709 Views |
May 17, 2010, 08:08:15 am by mattias |
|||
rs-232 wiring
Started by Seight-v8 |
2 Replies
6390 Views |
August 25, 2012, 05:50:00 am by boostd audi |
||
Running 2 knock sensors on my v8
Started by Tony C |
5 Replies
6804 Views |
July 05, 2009, 03:27:09 pm by Tony C |
||
s14a 1997 pinout to Vems pinout.
Started by wwc_gang |
0 Replies
4577 Views |
October 03, 2015, 04:52:37 pm by wwc_gang |
||
Schematic for VR to Hall converter
Started by Mads Lund |
5 Replies
10189 Views |
September 08, 2016, 11:54:44 pm by Kamuto |
||
SD Card connection schematics
Started by PIC |
1 Replies
4975 Views |
February 07, 2012, 09:19:18 am by Erikk |
||
second egt
Started by Seight-v8 |
5 Replies
7607 Views |
December 17, 2013, 07:54:49 pm by Kamuto |
||
secondary trigger used for wheel speed?
Started by PG |
0 Replies
4739 Views |
May 01, 2011, 11:00:23 am by PG |
||
Sensing a ground
Started by Wolf_Tm |
3 Replies
5000 Views |
April 20, 2017, 05:51:26 pm by fphil |
||
Sensor identification
Started by se7ensport |
1 Replies
6051 Views |
May 06, 2007, 01:54:29 pm by rob@vems.co.uk |
||
sensor near plug leads
Started by Seight-v8 |
2 Replies
5972 Views |
August 26, 2019, 11:18:10 am by Seight-v8 |
||
Sensor shields connection
Started by jadzwin |
8 Replies
8274 Views |
September 24, 2007, 01:25:24 pm by jadzwin |
||
sequential shift light.
Started by Tony C |
4 Replies
5501 Views |
December 04, 2009, 05:35:11 am by Tony C |
||
Setting up knock sensors properly?
Started by Manick |
2 Replies
5018 Views |
December 21, 2015, 08:25:55 am by Manick |
||
27 Replies
25363 Views |
March 05, 2009, 10:14:42 pm by Sanjuro |
|||
Shielded Wire, where to get it?
Started by bcool |
2 Replies
6314 Views |
November 04, 2007, 06:37:18 am by bcool |
Normal Topic
Hot Topic (More than 15 replies)
Very Hot Topic (More than 25 replies)
Locked Topic
Sticky Topic
Poll