News:
When asking for technical help at the very least let us know the version of firmware you are running.
Cliff's Calibration (Mapping) Guide is a MUST READ: http://www.vemssupport.com/forum/index.php/topic,97.0.html
| Subject / Started by | Replies  / Views |
Last post | ||
|---|---|---|---|---|
|
|
2 Replies
7109 Views |
February 14, 2011, 01:05:25 pmby z0tya |
|
|
|
|
ignition drivers
Started by reevio |
2 Replies
5530 Views |
September 25, 2011, 08:27:54 pm by reevio |
|
|
|
knock sensor
Started by reevio |
2 Replies
5508 Views |
May 09, 2011, 07:54:56 pm by reevio |
|
|
|
Half Moon Cam Sync
Started by dannyho |
2 Replies
5884 Views |
October 03, 2011, 08:28:04 pm by rob@vems.co.uk |
|
|
|
2 Replies
6419 Views |
January 23, 2011, 06:56:56 pm by MWfire |
|
|
|
|
2 Replies
9354 Views |
January 08, 2011, 12:20:45 am by rossi46numberone |
|
|
|
|
2 Replies
5478 Views |
June 06, 2014, 12:04:40 pm by MWfire |
|
|
|
|
EGT amplifier issues
Started by Ellisd |
2 Replies
6046 Views |
August 04, 2020, 12:53:31 pm by gunni |
|
|
|
Shift down light, any sugestions?
Started by se7ensport |
2 Replies
6673 Views |
June 03, 2007, 12:16:51 pm by se7ensport |
|
|
|
2 Replies
5437 Views |
October 06, 2010, 10:09:27 pm by reevio |
|
|
|
|
2 Replies
6072 Views |
May 23, 2012, 10:25:08 pm by Joof |
|
|
|
|
Nissan S13 Harness Adaptor
Started by rob@vems.co.uk |
2 Replies
6771 Views |
February 28, 2007, 07:51:46 pm by damo_S13 |
|
|
|
rs-232 wiring
Started by Seight-v8 |
2 Replies
6816 Views |
August 25, 2012, 05:50:00 am by boostd audi |
|
|
|
sensor near plug leads
Started by Seight-v8 |
2 Replies
6530 Views |
August 26, 2019, 11:18:10 am by Seight-v8 |
|
|
|
What makes "sensor ground" different?
Started by wazzu70 |
2 Replies
5319 Views |
January 21, 2013, 05:40:49 pm by wazzu70 |
|
|
|
water temp sensor replacement
Started by ex-ctr |
2 Replies
8018 Views |
February 09, 2007, 08:13:42 pm by ex-ctr |
|
|
|
Shielded Wire, where to get it?
Started by bcool |
2 Replies
6757 Views |
November 04, 2007, 06:37:18 am by bcool |
|
|
|
VEMS ETC Setup
Started by Brk97 |
2 Replies
4946 Views |
July 27, 2018, 03:26:29 am by jrussell |
|
|
|
Setting up knock sensors properly?
Started by Manick |
2 Replies
5545 Views |
December 21, 2015, 08:25:55 am by Manick |
|
|
|
flex fuel sensor input
Started by TC-Tuned |
2 Replies
6665 Views |
March 28, 2016, 06:46:47 pm by jrussell |
Normal Topic
Hot Topic (More than 15 replies)
Very Hot Topic (More than 25 replies)
Locked Topic
Sticky Topic
Poll