News:
When asking for technical help at the very least let us know the version of firmware you are running.
Cliff's Calibration (Mapping) Guide is a MUST READ: http://www.vemssupport.com/forum/index.php/topic,97.0.html
| Subject / Started by | Replies / Views  |
Last post | ||
|---|---|---|---|---|
|
|
Tach Fluctuation at high rpms
Started by Joof |
7 Replies
11041 Views |
November 14, 2012, 03:18:20 amby Joof |
|
|
|
2nd com port
Started by Seight-v8 |
6 Replies
10946 Views |
March 07, 2011, 08:23:22 am by z0tya |
|
|
|
E85 0-5v input VEMS anytrim setup
Started by Scottme262 |
11 Replies
10885 Views |
August 16, 2017, 04:13:38 am by Scottme262 |
|
|
|
Wheelspeed2 pre-wired to output pin?
Started by RazOn |
14 Replies
10739 Views |
November 30, 2016, 11:20:51 pm by RazOn |
|
|
|
fuel pressure sensor install
Started by njorge0319 |
7 Replies
10686 Views |
June 04, 2013, 08:19:45 pm by njorge0319 |
|
|
|
rev counter? Idle Air Controller (IAC)?
Started by damo_S13 |
5 Replies
10506 Views |
February 23, 2007, 11:49:59 pm by damo_S13 |
|
|
|
TIM rev counter
Started by tom70 |
5 Replies
10264 Views |
July 23, 2007, 09:28:29 pm by rob@vems.co.uk |
|
|
|
11 Replies
10233 Views |
March 31, 2011, 05:56:12 pm by silverliner |
|
|
|
|
Extra Input chanels
Started by Sprocket |
6 Replies
10211 Views |
April 12, 2007, 03:51:39 pm by rob@vems.co.uk |
|
|
|
VEMS support LSU 4.9 (4-93)?
Started by krzycho-g |
4 Replies
10171 Views |
August 29, 2010, 02:02:26 pm by paul_f |
|
|
|
Shift-Cut input signal
Started by Nack |
8 Replies
10111 Views |
April 28, 2010, 06:16:27 am by Nack |
|
|
|
table switch connection and setup
Started by darzamat |
4 Replies
10092 Views |
July 23, 2013, 08:19:06 pm by darzamat |
|
|
|
Subaru IAC valve (6 wire)
Started by M-Tech |
5 Replies
10051 Views |
August 22, 2008, 12:11:18 pm by Denmark |
|
|
|
Splicing EGT Sensors...
Started by jonboy |
3 Replies
10013 Views |
May 10, 2007, 10:15:36 pm by rob@vems.co.uk |
|
|
|
Boost vs Vehicle Speed
Started by danmartin |
8 Replies
10009 Views |
September 22, 2008, 10:14:13 pm by MWfire |
|
|
|
2 Replies
9988 Views |
January 08, 2011, 12:20:45 am by rossi46numberone |
|
|
|
|
6 Replies
9979 Views |
August 29, 2015, 04:03:21 pm by watahyahknow |
|
|
|
|
Intermittant operation of P259 output
Started by dnb |
10 Replies
9881 Views |
June 11, 2009, 06:10:42 am by Bat |
|
|
|
Faulty MAP Sensor
Started by scottish-sr |
12 Replies
9746 Views |
August 06, 2014, 09:07:19 am by gunni |
|
|
|
Error in VEMS harness diagrams
Started by irishtwincam |
4 Replies
9735 Views |
May 13, 2009, 04:28:35 am by irishtwincam |
Normal Topic
Hot Topic (More than 15 replies)
Very Hot Topic (More than 25 replies)
Locked Topic
Sticky Topic
Poll